Flash drives are a dime a dozen these days, and most of them carry uninteresting specifications. In particular, flash drives advertising smaller physical footprints have tended to carry disappointing performance numbers. We were surprised when Strontium sent us their announcement of the Nitro Plus Nano USB 3.0 flash drive with 100 MBps+ read speeds. We had reviewed the Mushkin Atom 64GB flash drive with a similar form factor, and the numbers claimed by Strontium were quite a bit more than what we managed to get with the Mushkin Atom. Intrigued by Strontium's performance claims, we got a sample in for further evaluation.

High-performance flash drives have traditionally employed a SATA SSD controller behind a USB 3.0 - SATA bridge. However, this increases the drive cost in what is essentially a price-sensitive market. Vendors have recently begun to introduce native high-performance USB 3.0 flash controllers, and the Strontium Nitro Plus Nano sports one such controller. The list of flash drives used for comparison purposes is provided below:

  • SanDisk Extreme 64GB
  • Mushkin Atom 64GB
  • Strontium Nitro Plus Nano 64GB

Hardware Design and Internals

In terms of external design and features, the Strontium Nitro Plus Nano USB 3.0 drive is small and discreet. A red cap that protrudes 8mm from the USB slot and has a total width of only 16mm ensures that the unit can fit in easily even in the ill-placed / oriented USB ports. A small hole at the top accommodates the bundled thread that enables hanging the flash drive off a keychain. As we can see from the photograph below, the Strontium Nitro Plus Nano USB 3.0 is one of the smallest flash drives that we have evaluated in its capacity class.

Without opening up the unit, it is possible to identify the controller and flash inside the unit.

The controller is the Silicon Motion SM3267 single-channel USB 3.0 controller. This appears to be an ideal controller for low-cost flash drives with a small physical footprint because it reduces BOM (bill-of-materials) cost as well as PCB area by integrating the required power IC and crystal oscillator. Depending on the flash memory used, Silicon Motion claims performance of up to 160 MBps reads. Strontium has gone in for Samsung TLC NAND in the flash drive. This must be compared to the Phison PS2251-07 used along with Toshiba TLC NAND in the Mushkin Atom 64GB drive.

Testbed Setup and Testing Methodology

Evaluation of DAS units on Windows is done with the testbed outlined in the table below. For devices with USB 3.0 connections (such as the Strontium Nitro Plus Nano that we are considering today), we utilize the USB 3.0 port directly hanging off the PCH.

AnandTech DAS Testbed Configuration
Motherboard Asus Z97-PRO Wi-Fi ac ATX
CPU Intel Core i7-4790
Memory Corsair Vengeance Pro CMY32GX3M4A2133C11
32 GB (4x 8GB)
DDR3-2133 @ 11-11-11-27
OS Drive Seagate 600 Pro 400 GB
Optical Drive Asus BW-16D1HT 16x Blu-ray Write (w/ M-Disc Support)
Add-on Card Asus Thunderbolt EX II
Chassis Corsair Air 540
PSU Corsair AX760i 760 W
OS Windows 8.1 Pro
Thanks to Asus and Corsair for the build components

The full details of the reasoning behind choosing the above build components can be found here.

Synthetic Benchmarks - ATTO and Crystal DiskMark

Strontium claims read and write speeds of 130 MBps and 100 MBps respectively, and the read number is backed up by the ATTO benchmarks provided below. Writes only seem to go up to 60 MBps with our standard testing queue depth. Unfortunately, these access traces are not very common in real-life scenarios.

CrystalDiskMark, despite being a canned benchmark, provides a better estimate of the performance range with a selected set of numbers. As evident from the screenshot below, the performance can dip to as low as 0.615 MBps for random 4K writes.

Benchmarks - robocopy and PCMark 8 Storage Bench

Our testing methodology for DAS units also takes into consideration the usual use-case for such devices. The most common usage scenario is transfer of large amounts of photos and videos to and from the unit. The minor usage scenario is importing files directly off the DAS into a multimedia editing program such as Adobe Photoshop.

In order to tackle the first use-case, we created three test folders with the following characteristics:

  • Photos: 15.6 GB collection of 4320 photos (RAW as well as JPEGs) in 61 sub-folders
  • Videos: 16.1 GB collection of 244 videos (MP4 as well as MOVs) in 6 sub-folders
  • BR: 10.7 GB Blu-ray folder structure of the IDT Benchmark Blu-ray (the same that we use in our robocopy tests for NAS systems)

robocopy - Photos Read

robocopy - Photos Write

robocopy - Videos Read

robocopy - Videos Write

robocopy - Blu-ray Folder Read

robocopy - Blu-ray Folder Write

For the second use-case, we take advantage of PC Mark 8's storage bench. The storage workload involves games as well as multimedia editing applications. The command line version allows us to cherry-pick storage traces to run on a target drive. We chose the following traces.

  • Adobe Photoshop (Light)
  • Adobe Photoshop (Heavy)
  • Adobe After Effects
  • Adobe Illustrator

Usually, PC Mark 8 reports time to complete the trace, but the detailed log report has the read and write bandwidth figures which we present in our performance graphs. Note that the bandwidth number reported in the results don't involve idle time compression. Results might appear low, but that is part of the workload characteristic. Note that the same testbed is being used for all DAS units. Therefore, comparing the numbers for each trace should be possible across different DAS units. In any case, the PCMark 8 storage workloads are hardly the type of traces that would ever run on drives such as the Nitro Plus Nano.

In general, these results show that the Stronitum drive performs better than the Mushkin one in most relevant benchmarks. The Mushkin is the only one that can be used for apples-to-apples comparison, since the SanDisk drive employs a SATA controller behind a USB 3.0 - SATA bridge, and has a much bigger physical footprint.

robocopy - Photoshop Light Read

robocopy - Photoshop Light Write

robocopy - Photoshop Heavy Read

robocopy - Photoshop Heavy Write

robocopy - After Effects Read

robocopy - After Effects Write

robocopy - Illustrator Read

robocopy - Illustrator Write

Performance Consistency

Yet another interesting aspect of these types of units is performance consistency. Aspects that may influence this include thermal throttling and firmware caps on access rates to avoid overheating or other similar scenarios. This aspect is an important one, as the last thing that users want to see when copying over, say, 50 GB of data from the flash drive, is the transfer rate going to USB 2.0 speeds. In order to identify whether the drive under test suffers from this problem, we instrumented our robocopy DAS benchmark suite to record the flash drive's read and write transfer rates while the robocopy process took place in the background. For supported drives, we also recorded the internal temperature of the drive during the process. The Strontium unit, however, doesn't expose the temperature over the USB interface. The graphs below show the speeds observed during our real-world DAS suite processing. The first three sets of writes and reads correspond to the photos suite. A small gap (for the transfer of the videos suite from the primary drive to the RAM drive) is followed by three sets for the next data set. Another small RAM-drive transfer gap is followed by three sets for the Blu-ray folder.

An important point to note here is that each of the first three blue and green areas correspond to 15.6 GB of writes and reads respectively. Throttling, if any, is apparent within the processing of the photos suite itself.

Despite the small size, the Strontium unit has not problems with sustaining the expected transfer rates and there seems to be no thermal throttling at play. The write rates are quite disappointing for small-sized files, but, that is to be expected given the nature of the device.

Concluding Remarks

The performance of the drive is impressive when one considers the size of the unit. Obviously, the numbers are not going to be similar to what a real SSD controller with multiple flash chips can give us. This brings us to the most important aspect in this particular market niche - the pricing. As per the press release, the Strontium Nitro Plus Nano USB 3.0 64GB drive is expected to cost $20.

Price per GB

The Strontium unit manages to beat the Mushkin Atom in both pricing and performance numbers for real-life workloads. In addition, Windows reports an usable capacity of 60.44 GB with the Strontium unit, while the Mushkin one comes in at 57.70 GB only. When it comes to packing a punch in the smallest possible form factor for a USB 3.0 flash drive, the Strontium Nitro Plus Nano USB 3.0 is the king of the hill right now. Pretty much the only complaint that could be made against the unit is the absence of a protective covering for the USB connector.

Comments Locked

21 Comments

View All Comments

  • James5mith - Monday, August 3, 2015 - link

    Would love to see a new generation USB 3.0 capable drive in a Verbatim "Tuff n' Tiny" format. With the single piece, epoxy-sealed design, it's still the most reliable USB drive I've ever used. I just want the same thing, but with faster transfer speeds.
  • Shadowmaster625 - Monday, August 3, 2015 - link

    With USB 3.0 in a Verbatim "Tuff n' Tiny" format, I think you'd end up with skinnier pads, which might get scratched off?
  • casperes1996 - Monday, August 3, 2015 - link

    I want 4 of the SanDisk Extremes in RAID... Anyone willing to give?
  • bill.rookard - Monday, August 3, 2015 - link

    That would be kind of cool, but even with the Strontium unit reviewed here, you could theoretically do the same thing, and assemble a 256GB flash drive array for about $80.00 which is actually a pretty good price. Write speed could hit 120MB/sec, read speed 520MB/sec which is pretty darn respectable, and actually would be cheaper than a comparable 256Gb SSD.
  • FaaR - Wednesday, August 5, 2015 - link

    Such a RAID drive would be unreliable as hell I would think. Striping four drives means 4x the error rate compared to a single drive, then add el cheapo TLC flash, with rock bottom amounts of internal error checking and correction (if any at all), rock bottom wear leveling, spare area and so on. Also, no trim support. And on top of all that, USB flash sticks aren't meant as long-term storage either.

    Some months ago, data was released that showed that some flash memories lose their data in literally only days of elevated temperatures for example - and the same thing happens at room temperature too by the way, only slower. And with the terrible error correction you'll have in this thing and 4x RAID 0, prepare to have your stuff going buh-bye in no-time. :P
  • lilmoe - Monday, August 3, 2015 - link

    As I was reading this, and idea popped in my head. These cards are basically NAND, and NAND itself is relatively one of the least costing components of the entire package, I believe that Intel's 3D XPoint memory would make a GREAT alternative for professionals in this form factor. It's much faster (basically doesn't need parallelism to achieve high speeds), much more reliable, and definitely MUCH more durable. Some professionals probably wouldn't mind paying double(?) the price for the added confidence in parts that would last years.
  • smorebuds - Tuesday, August 4, 2015 - link

    you mean as an alternative for usb flash drives? it'd still be bottlenecked by usb 3.0.
  • lilmoe - Tuesday, August 4, 2015 - link

    3.1?
  • lilmoe - Tuesday, August 4, 2015 - link

    Besides, even if bottle-necked, the speed would be much, MUCH faster than any flash drive or SD card out there... The point here is reliability and endurance. Some photographers, IT professionals and business users wouldn't mind the extra cost for the added confidence in the product.
  • FaaR - Wednesday, August 5, 2015 - link

    As you can tell from the diagrams in this review, these flash drives aren't bottlenecked by USB3 at all during real-world usage scenarios. Heck, in some of these tests they would only barely be bottlenecked by USB1.x... ;)

Log in

Don't have an account? Sign up now